Related Manuals for Tallymatics TW5350
Summary of Contents for Tallymatics TW5350
- Page 1 TW5350 Installation Manual TW5350 Installation Manual Visit us on the web: www.tallymatics.com Document # 61-5350-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Equipment Installation and Operation ................. 6 Information regarding installation ................. 6 Installation Considerations ....................6 RJ45 Cable Connector ......................7 Device Communication ....................... 7 NMEA Messages ........................8 TW5350 Configured Settings .................... 8 Flash Configuration ......................8 TW5350 Mechanical........................9... -
Page 4: Introduction
The TW5350 outputs standard NMEA 0183 output with navigation updates rates up to 5 Hz. The TW5350 supports RS232 as the serial interface with RS485 for the 1PPS time pulse. The input operating voltage supports a range of 5V to 36V. -
Page 5: Regulatory Notice
TW5350 Installation Manual Figure 2 TW5350 Antenna (Conical white shown) 2 Regulatory Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that the device does not cause harmful interference. This device may only be used if operated or installed in a transportation vehicle including motor vehicles and aircraft, all other modes of use are prohibited. -
Page 6: Equipment Installation And Operation
Recommended minimum 10cm ground plane with the antenna located at the center. The TW5350 has a 5-meter cable terminated with an RJ45 connector. Adaptor cables are available to interface to a PC and a variety of mobile radio devices. Please contact Tallymatics for details. -
Page 7: Rj45 Cable Connector
Figure 2 RJ45 - I/O Connector (looking onto the connector contacts) Device Communication The TW5350 smart antenna has been factory configured for out of the box operation. When the device is powered, NMEA messaging will be active immediately on the RS-232 TX signal pin. -
Page 8: Nmea Messages
GNGSA GPGSV GLGSV GAGSV GNGLL TW5350 Configured Settings The TW5350 has been configured with the following specific settings set: NMEA Version -> 4.1 (Required to support Galileo Constellation) Position Output Rate: 1Hz GNSS Configuration o GPS o GALILEO o GLONASS o w/ SBAS Navigation Dynamic Model ->... -
Page 9: Tw5350 Mechanical
TW5350 Installation Manual 4 TW5350 Mechanical Figure 3 Mechanical dimensions of the TW5350...