Related Manuals for Tallymatics TW5362
Summary of Contents for Tallymatics TW5362
- Page 1 TW5362 Installation Manual TW5362 Installation Manual Visit us on the web: www.tallymatics.com Document # 61-0007-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Installation Considerations ....................6 Operational Considerations....................6 RJ45 Cable Connector ......................7 Device Communication ....................... 8 NMEA Messages ........................8 TW5362 Configured Settings .................... 8 Inertial Calibration Status ....................9 Flash Configuration ......................9 3.10 Evaluation Tools ........................ 9 3.11 Developer References...................... -
Page 4: Introduction
UDR positioning starts as soon as the ignition signal is applied and before the first GNSS fix is available. The TW5362 may be installed in any position in a vehicle without electrical connection to the vehicle speed sensor. The on-board accelerometer and gyroscope sensors result in a self-contained UDR which is self calibrating and provides reliable and consistent navigation. -
Page 5: Regulatory Notice
3 Equipment Installation and Operation Information regarding installation Tallymatics provides wiring instructions to electrically connect the TW5362 device to the vehicle battery in a manner consistent with industry best practices. Improper installation of aftermarket electronics within a vehicle can negatively impact the safety and security of the Driver (and Passengers) and could result in serious injury or death in the event of a collision. -
Page 6: Installation Considerations
UDR performance. The TW5362 has a 5-meter cable terminated with an RJ45 connector. Adaptor cables are available to interface to a PC and a variety of mobile radio devices. Please contact Tallymatics for details. -
Page 7: Rj45 Cable Connector
TW5362 Installation Manual RJ45 Cable Connector The smart antenna cable is terminated with an 8 position RJ45 signal connector which provides the following signals: Description Notes Color White/Green <OPEN> Green (5-36 VDC) White/Orange IGN/ENA ON(>5V) / OFF(<4V) Blue IGN/ENA OUT... -
Page 8: Device Communication
TW5362 Installation Manual Device Communication The TW5362 smart antenna has been factory configured for out of the box operation. When the device is powered and enabled, NMEA messaging will be active immediately on the RS-232 TX signal pin. The device has been factory configured as: 9600,8,N,1... -
Page 9: Inertial Calibration Status
3-4 minutes of operating the vehicle in typical driving conditions providing the minimum quantity of each event type has been acquired. Note: The current state of the TW5362 sensor calibration may be polled using the ESF/STATUS message via the u-center development tool or directly from an embedded vehicle computing system. -
Page 10: Tw5362 Mechanical
TW5362 Installation Manual 4 TW5362 Mechanical Figure 3 Mechanical dimensions of the TW5362...