Related Manuals for Tallymatics TW5390
Summary of Contents for Tallymatics TW5390
- Page 1 TW5390 Manual TW5390 Multi-Band Precision Receiver/Antenna with L-Band Augmentation Manual Visit us on the web: www.tallymatics.com Document # 61-0090-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Equipment Installation and Operation ................. 5 Installation Considerations ....................5 IMU Operational Considerations ..................5 Hardware Interface ........................6 Device Communication ....................... 7 TW5390 Configured Settings .................... 7 Simplified Configuration Tool ..................8 TruPrecision ..........................8 Evaluation Tools ........................8 Developer References ......................8... -
Page 4: Introduction
Inertial Measurement Unit (Untethered Dead Reckoning) and integrated L-Band augmentation receiver for stand-alone RTK for Precise Point Positioning. The TW5390 is capable of providing sub 10 cm accuracy to support the most demanding navigation, automation and precision agriculture applications. -
Page 5: Equipment Installation And Operation
2 Equipment Installation and Operation Installation Considerations The TW5390 is mounted using the integrated 19mm (3/4”) fixed mount feature. For optimal performance, the device should be securely mounted to a rigid surface with a minimum ground plane diameter of 10cm. Please note that the TW5390 GNSS receiver contains multi-axis inertial sensors which perform an auto calibration at power up. -
Page 6: Hardware Interface
TW5390 Manual 3 Hardware Interface The standard TW5390 is provided with a 5 m cable terminated in a RJ45 connector. Figure 2 Table 1... -
Page 7: Device Communication
TW5390 Manual 4 Device Communication The TW5390 smart antenna has been factory configured for out of the box operation. When the device is powered, NMEA messaging will be active immediately on the RS-485/422 TX signal pins. The serial interface has been factory configured as: 230400,8,N,1... -
Page 8: Simplified Configuration Tool
TW5390 antenna receiver to the u-blox Thingstream service and subscribe to the PointPerfect® SPARTN augmentation stream to experience a true “Out of Box” precision performance from the TW5390. The TW5390 TruPrecision Windows service application and quick start guide may be downloaded at the following link: https://tallysman.com/downloads/TruPrecision.zip... -
Page 9: Tw53902 Mechanical
The TW5390 Antenna assembly contains the following parts: TW5390 receiver Antenna with 5 Meter cable and RJ45 termination Two 0.75” (19mm) panel nuts. One metal washer A rubber gasket installed on the lower side of the TW5390 Figure 2 TW5390 Install Mechanical...