Philips Salon Geometricks 10-in-1 User Manual page 8

ENGLISH
8
Follow this procedure for all attachments. To detach the
attachments, turn the locking ring to the left and pull the
attachment out of the handle.
Unplug the appliance when you remove an attachment after or
during styling. Avoid touching the metal and ceramic parts of the
attachment, as they are hot.
Using the appliance
With the Salon Geometricks 10-in-1 you can create tight curls, large
curls, waves, ringlets, crimps, zig-zag curls, triangular curls and a sleek
look.
1 After having connected the attachment to the handle, place the
appliance on the stand of the attachment and put the mains plug
in the wall socket. The pilot light goes on and the appliance starts
heating up (fig. 3).
2 Start styling when the ready dot on the attachment changes
colour (fig. 4).
3 When using one of the curling attachments or the brush, always
make sure the end of the lock is wound in the required direction.
4 How long you have to keep the styler in your hair depends on
the thickness of your hair. If you have fine hair, 5 seconds will be
long enough for a good result. Leave the styler in your hair
longer (max. 10 seconds) if your hair is thicker.
Large or tight curls
1 Connect the large or small curling attachment to the handle.
Make sure that the stand is pointing downwards.
2 Take a lock of hair, open the clip by pressing the lever and place
the lock between the barrel and the clip (fig. 5).
3 Release the lever and slide the barrel to the end of the lock.
Then wind the lock round the barrel.