Technics SA-DA20 Operating Instructions Manual page 13

3 4
Customizing your receiver
Basic
eoais
If you allow about 10 seconds to elapse between settings, the
procedure is canceled, all settings are returned to how they were, >
and the previous display is restored. Begin again if this occurs.
1
Press [POWER, cb/l].
2
press [A]'and [B] at the same time.
3
Press [A] to select the item you want
to change.
Each time you press the button:
SI2E-*DISTANCE-FILTER-*DR COMP-D-INPUT- DIMMER
1_I
4
Change the settings below).
Repeat steps 3 and 4 to complete the necessary
settings.
SIZE, DISTANCE. D-INPUT
-SPEAKERS-
INPUT SELECTOR
5
Press [A] and [B] at the same time.
Changing the settings
SIZE
(D Press [B] to select the speaker you want to set.
Each time you press the button:
FRONT — CENTER — SURROUND — SUB-WFR (Subwoofer)
t_I
(D
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
FRONT: SMALL — LARGE
CENTER and SURROUND: NONE SMALL — LARGE
SUB-WFR: NO — YES
(D
Repeat ® and
(D
to change other SIZE settings.
DISTANCE
0 Press [B] to select the speaker you want to set.
Each time you press the button;
FRONT — CENTER — SURROUND
t_I
0 Turn [INPUT SELECTOR] to set the distance.
0
Repeat
0
and
0
to change other DISTANCE settings.
FILTER
Turn [INPUT SELECTOR] to set the cut-off.
When you turn the selector:
100 — 150 — 200
DR COMP
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF — STANDARD — MAX
D-INPUT
0 Press [B] to select the input position you want to set.
Each time you press the button:
CD COAX — DVD OPT2 — TV OPTl
t_I
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other
corresponding setting will also change.
0Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX — OPT1 — OPT2
t_I
0 Repeat 0 and @ to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF — ON
RQT5982