Advertisement
Available languages
Available languages
EN
11. Fold the outer section on the right side like
a fan so that the release unit is on top. Let
the release line and handle hang down the
bottom in the cover.
IMPORTANT: Make sure that the release line
and handle are free-hanging on the right
side from the buckle on the protective cover.
12. Close zipper. Close the hook and loop
fastener. Check that the release unit is visible
in the window.
13. Push zipper ends inside the cover, close the
push buttons to keep zipper ends inside the
cover.
14. Place the release line underneath the flaps
and the release handle in the holder.
4.4 REPLACING THE CO2-CYLINDER AND BOBBIN
– HALKEY ROBERTS
After use in freshwater dry the lifejacket. If the
lifejacket has been used in saltwater, it must be
rinsed with fresh water and then dried. Remove
any air in the lifejacket using the oral inflation
valve.
DISASSEMBLY
Please see figure 1 and 2 on page10
Step 1:
Unpack or open the lifejacket so that the
inflator is visible. Remove the protective
neoprene cover. Slide the cylinder holder and
O-ring (figure 2) down so it is not holding on to
the manifold nut. Unscrew the cylinder from the
inflator.
Step 2:
Remove gas CO2 cylinder by rotating cylinder
counter-clockwise and removing the cylinder
from holder and O-ring. Discard cylinder.
Step 3:
Remove the cap by turning counter-clockwise.
Step 4:
Remove the bobbin from the cap or housing
unit. Discard bobbin (yellow). Check the housing
to be sure it is clear and dry.
4
VIKING RESCYOU
™
PRO 1F
V95000
®
®
PRIME LIFEJACKET (PV9280)
Note: The bobbin (yellow) body may remain in
the housing or in the cap assembly when
you remove the cap. The bobbin body must be
removed before rearming.
REARMING
Note: Rearming must follow the sequence
below.
Step 5:
A new bobbin must be used. New bobbin must
have been purchased within four (4) years. If the
bobbin purchase date is unknown, check the
date on the bobbin and replace it if it is more
than four (4) years.
Step 6:
IMPORTANT!
Bobbin (yellow) must be installed into the
housing (see figure 1), white side up, aligning
the slots on the bobbin with the ridges inside
the threaded housing. The bobbin will slide in
easily if installed correctly.
Step 7:
Install cap by screwing clockwise until it meets
the housing shoulder. Note: There should be no
gap between the cap and the housing shoulder.
Step 8:
Check the new cylinder to be sure it has not
been punctured.
Step 9:
Install a new cylinder by engaging the cylinder
threads with the inflator threads. Turn the
cylinder clockwise till a firm seal is achieved.
WARNING: Lifejacket will only inflate if the
cylinder is turned to a full stop.
Slide the O-ring and the cylinder holder onto
the holder and into the groove. Slide the
cylinder holder and O-ring over the cylinder. The
cylinder holder and O-ring assembly should be
holding the manifold nut. Mount the protective
neoprene cover.
Step 10:
Make sure the service indicator is green.
Advertisement
