Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this Box Scraper is the responsibility of
the WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal conditions.
The Box Scraper is shipped partially assembled.
Assembly will be easier if components are aligned and
loosely
assembled
Recommended torque values for hardware are located
on page 20.
■ Before dismounting power unit or perform-
ing any service or maintenance, follow these
steps: disengage power to equipment, lower
the 3-point hitch and all raised components to
the ground, operate valve levers to release any
hydraulic pressure, set parking brake, stop en-
gine, remove key, and unfasten seat belt.
■ NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equip-
ment or between moveable parts even when the
engine has been turned off. Hydraulic system
leak-down, hydraulic system failures, mechan-
ical failures, or movement of control levers can
cause equipment to drop or rotate unexpectedly
and cause severe injury or death.
•
Service work does not require going under-
neath implement.
•
Read Operator's Manual for service in-
structions or have service performed by a
qualified dealer.
■ Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing,
and head; and respirator or filter mask where
appropriate.
MAN0179
( 06/07/2023 )
MAN0179_2023-06.indd 13
MAN0179_2023-06.indd 13
ASSEMBLY
before
tightening
hardware.
WARNING
CAUTION
REMOVE COMPONENTS
1. Remove banding that holds box scraper to pallet.
2. Remove lag bolts securing A-frame support bars (8)
to the pallet.
3. Remove cap screws (28), lock washers (27), and
hex nuts (26) that secure A-frame bars (6) to the
rear of scraper frame.
4. Remove hex nuts (31) and lock washers (30) from
mounting pins.
30, 31
8
6. A-frame bars (set)
8. A-frame support bars
26. 3/4 NC Hex nut
27. 3/4 Lock washer
28. 3/4 NC x 2 Cap screw
30. 7/8 Lock washer
31. 7/8 Hex nut
Figure 7. Shipping Configuration
28
31
30
8
Figure 8. Remove Components
Assembly 13
26, 27, 28
6
CD6163-2
27
26
6
DP3
2/8/24 9:43 AM
2/8/24 9:43 AM
Advertisement
Table of Contents
