Scarifying; Scraping; Leveling; Storage - Woods GBC48 Operator's Manual

SCARIFYING

1. Place the scarifier shanks in position with the points
facing toward the tractor.
2. Lock into position with the pins provided. The
lower shank position provides the greatest ground
penetration.
3. Lower the box scraper and drive the tractor ahead
to begin the scarifying operation.
4. Adjust the depth of the scarifier by tilting the unit
with the tractor top link. Shortening the top link will
provide deeper and more aggressive operation.

SCRAPING

1. Raise or remove the scarifier shanks (see page 11).
Lower the box scraper and drive forward to move
material.
2. Adjust the depth of the blade by tilting the unit with
the tractor top link.
NOTE: Shortening the top link when scraping will
transfer more weight on the front of the scraper and
will raise the cutting blade to provide a more shal-
low cut.
NOTE: When the top link is adjusted properly, the
bowl of the blade should fill easily and material can
be pulled to a desired location.
10 Operation
MAN0179_2023-06.indd 10 MAN0179_2023-06.indd 10

LEVELING

1. Raise or remove scarifier shanks.
2. Shorten the top link so the cutting edge clears the
ground.
3. Drive forward with the box scraper in this position
and loose material will be leveled.

STORAGE

■ To help prevent injury caused by a falling imple-
ment, always detach on a hard level surface.
■ Block equipment securely for storage (see
Figure 4).
■ Do not climb or lean on equipment stored on
stand.
MAN0179
( 06/07/2023 )
2/8/24 9:43 AM 2/8/24 9:43 AM