Replacing Scarifier Shank Tooth; Cleaning - Woods GBC48 Operator's Manual

20
2
Figure 5. Scarifier Shanks Installed
REPLACING SCARIFIER TOOTH
1. Remove scarifier shank (1) from the scarifier bar.
2. Remove the worn tooth by driving a chisel between
the shank (1) and tooth (2) .
3. Install replacement tooth and use a punch (3) to
bend the locking tab (4) into the retaining hole on
both sides of the shank (see Figure 6).
4. Reinstall the shank (1) in the scarifier bar.
1. Shank
2. Tooth
3. Punch
4. Locking Tab
2
Figure 6. Scarifier Point Replacement
12 Owner Service
MAN0179_2023-06.indd 12 MAN0179_2023-06.indd 12
3
CD6169
1
4
3
LA2

CLEANING

After Each Use
■ Remove large debris such as clumps of dirt,
grass, crop residue, etc. from machine.
■ Inspect machine and replace worn or damaged
parts.
■ Replace any safety decals that are missing or
not readable.
Periodically or Before Extended Storage
■ Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
■ Remove the remainder using a low-pressure
water spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or scratched
paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice of the
pressure washer manufacturer.
■ Inspect machine and replace worn or damaged
parts.
■ Sand down scratches and the edges of areas
missing paint and coat with Woods spray paint
of matching color (purchase from your Woods
dealer).
■ Replace any safety decals that are missing
or not readable (supplied free by your Woods
dealer). See Safety Decals section for location
drawing.
MAN0179
( 06/07/2023 )
2/8/24 9:43 AM 2/8/24 9:43 AM