Kohler Command PRO CH440 Service Manual page 36

Governor System
Electronic Governor Troubleshooting Flow Chart Continued
Inspect wiring harness for any broken or bad connections.
Repair/Replace as necessary.
Test control system of equipment.
Refer to Equipment Manufacturer's
diagnostic procedures for control
system.
Basic Wiring Harness Assembly Diagram
J1
36
Engine starts but does not keep running.
YES NO
Terminal K10 and B1 are located in J1, Pin H (shown below).
Disconnect K10 and B1 terminals on wiring harness and retest.
YES
END
YES
A B C D
H
G F E
KohlerEngines.com
Start engine in normal manner
as described in Owner's
Manual.
Does engine remain running?
OK?
NO
Test control system of
equipment. Refer to
Equipment Manufacturer's
diagnostic procedures for
control system.
J2
NO
Replace electronic
governor control and
retest.
HI-1
HI-2
K10
B1
17 690 01 Rev. L