Kohler Command PRO CH440 Service Manual page 13

TORQUE SPECIFICATIONS
Crankcase
Oil Drain Plug
Closure Plate Screw
Cylinder Head
Fastener (torque in 2 increments)
Electric Starter
Mounting Screw
Electric Starter Drive CH440 Type II Starter
Assembly Screw 5 mm
Brush Lead Connector Wire Screw 4 mm
Electric Starter Relay (Solenoid) CH395, CH440
Mounting Screw
Nut
Flywheel
Retaining Nut
Fuel Tank
Mounting Nut
Mounting Screw
Inlet Fitting
Gear Reduction
M6 Screws
M8 Screws
Governor (Electronic)
Electronic Governor Control to Crankcase
Governor (Mechanical)
Lever Nut
Throttle Control Lever Nut
Ignition
Spark Plug
Module Fastener
Oil Sentry Float Switch Screw
™
Oil Sentry Module Screw
™
Oil Sentry Wire Lead Nut
™
Stator Fastener (if equipped)
4
Values are in Metric units. Values in parentheses are English equivalents.
6 Lubricate threads with engine oil prior to assembly.
17 690 01 Rev. L
4,6 CH245/CH255
First to 12 N·m (106 in. lb.)
Finally to 24 N·m (212 in. lb.)
(89 in. lb.)
(89 in. lb.)
KohlerEngines.com
CH260/CH270
18 N·m (13 ft. lb.)
24 N·m (212 in. lb.)
24 N·m (212 in. lb.)
--- ---
--- ---
--- ---
--- ---
74 N·m (655 in. lb.)
10 N·m
10 N·m
1.5 N·m (13 in. lb.)
7.4 N·m (66 in. lb.)
24.4 N·m (216 in. lb.)
---
12 N·m (106 in. lb.)
9 N·m (80 in. lb.)
27 N·m (20 ft. lb.)
10 N·m (89 in. lb.)
8 N·m (71 in. lb.)
3.5 N·m (31 in. lb.)
10 N·m (89 in. lb.)
10 N·m (89 in. lb.)
Specifi cations
CH395 CH440
First to 18 N·m First to 25 N·m
(159 in. lb.) (221 in. lb.)
Finally to Finally to
36 N·m 57.5 N·m
(319 in. lb.) (509 in. lb.)
--- 5.8 N·m (51 in.
--- 1.7 N·m (15 in.
3.2 N·m (28 in. lb.)
4.5 N·m (40 in. lb.)
113 N·m (1000 in. lb.)
24 N·m (212 in. lb.)
24 N·m (212 in. lb.)
24 N·m (212 in. lb.)
lb.)
lb.)
13