Cub Cadet 1130 SWE Operator's Manual page 13

Auger
Pulley
Idler
Pulley
Support
Bracket
Rear
Auger
Belt
Front
Auger Belt
Idler Spring
Figure 13
Drive Belt
• Follow the first four steps of the instructions for
servicing the auger belts.
• Pull the idler pulley up and lift the belt off the wheel
drive pulley and friction wheel disc. See Figure 13.
Friction
Wheel
Stop Bolt
Support Bracket
Figure 14
•
Drive
•
Pulley
Drive
Belt
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.
Idler
Pulley
Replacing Friction Wheel Rubber
Auger
The rubber on the friction wheel is subject to wear and
Belts
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Frame
•
•
•
•
Frame
•
Drive
Support
Cover
Bracket
Screw
Spring
Auger Housing
•
Drive Plate
•
Auger Pulley
13
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 14.
Slip the belt between the friction wheel and drive
disc. Remove and replace the belt. Reassemble
following the instructions in reverse order.
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Remove the click pin that secures the left wheel to
the axle and slide the wheel from the axle.
Remove the four screws securing the left drive
cover to the frame. Remove the drive cover.
See Figure 15.
Figure 15
Holding the friction wheel assembly, slide the hex
shaft out of the left side of the frame. The spacer on
the right side of the hex shaft will fall and the
sprocket should remain hanging loose in the chain.
See Figure 16.
Lift the friction wheel assembly out between the
axle shaft and the drive shaft assemblies.
Left Axle
Left Drive
Cover