Introduction Assembling - Hally-Gally Piccolo Assembly Instructions Manual

1

Introduction Assembling

General information
This equipment should be installed, inspected, maintained and operated in
accordance with EN1176-7 guidelines.
The BG/GUV-SI 8095 is the basis of For Installation in schools and kindergarden
in Germany
We advise against the installation in sand!
Please consider that the installation has to be carried out only on even
terrain (max. slope up to 3%).
Before installation work commences, please check that you have all of the
equipment and fixation components in the parts list provided (Table 3).
Any spare parts that may be required can be obtained directly from your supplier
or from Spogg Sport Güter GmbH
address: Spogg Sport-Güter GmbH
Schulstr. 27
35614 Asslar/Berghausen
Tel. +49 6443 811262
Fax +49 6443 811269
Please do not hesitate to call your supplier if you have any problems during instal-
lation or with any other questions.
Tel. +49 6443 811262.
Following installation, complete assembly instructions, maintenance in-
structions and a maintenance record must be sent to the operator who
must confirm receipt in writing. See the last page of this document.
All nuts and bolts are hot-dip galvanised or stainless steel.
One of the characteristics of stainless steel is that uncontrolled cold
welding may occur when the nuts are tightened. To prevent this, it is
necessary to spray the nuts and bolts with Teflon spray or another simi-
lar lubricant.
We hereby confirm that this play equipment has been tested
and certified in accordance with the play equipment standard EN 1176-1:2017
SPOGG Sport-Güter GmbH • Schulstr. 27 • 35614 Aßlar/Berghausen
• www.hally-gally-spielplatzgeraete.de
spogg@hally-gally-spielplatzgeraete.de
You can reach us at the following:
4