Table of Contents
Advertisement
•
2.5
VIDEO
INPU~S
Connect Red,
g~een
and blue video to the
appropr~a~e
vi~eo
input connectors located on the rear connector panel.
Refer to Table 2-1.
Table video cables should be con-
structed with 75
n
coaxial cable (type RG59/U, or equiv-
alent) and te=minated, at the monitor cable end, with
standard ENC
co~~ector
plugs.
If the monitor is used
without sync signal input, the
gree~
video signal
to the monitor must contain composite sync.
.
...
l.npu,-
The Model C-6479 Series (13-inch) monitor contains two con-
nectors for each video
i~put
to provide for
loop-t...~rough
operation.
In addition, the input impedance 0= each input
may be set to a high impedance or to 75
n
by means of
,
=ive
input impedance selector switches, located next to
the video input connectors.
If the monitor is used in a
loop-through position, these switches should be set to
the high impedance position.
For single unit operation,
or when the monitor is the last unit in a
loop-t...~rough
string, these switches should be set to the 75
n
positio~
to terminate the video cable.
2 .6
AC INPUT POWER
Before connecting the monitor to the power source, deter-
mine
t...~at
the line voltage and frequency are proper
(100~
120 V AC or
220~240
V AC, 50/60 Hz).
Check the position
of the input voltage plug (P.) on the PCB-POwLR.
Make
certai~
that the plug (P.) is in the proper position for
the input line voltage
(lOO~120
V AC or
220~240
V AC,
50/60 Hz).
Plug the ac line cord into
t...~e
power recep-
tacle on the rear VIDEO panel.
2-2
;;-
Advertisement
Table of Contents
