Table of Contents
Advertisement
Available languages
Available languages
EN
About This Guide
The LΩGIC Wall Controller Instructions has basic product information. Download the User Manual for the
LΩGIC Drive 2X from
www.iluminarc.com
Overview
1–8
9
The LΩGIC Wall Controller is a wall-mounted control panel which plugs into an RJ12 connector on the back of the
LΩGIC Drive 2X.
•
Buttons 1–8 trigger playback of the corresponding recorded programs.
•
Buttons 9 and 10 decrease and increase the brightness of the connected LΩGIC products.
Binary Addressing
Set the address of the LΩGIC Wall Controller from 0–31 with the 5-bit DIP switches on the back of the product. The
numbers of each individual switch are upside down and ordered from right to left.
•
Each switch has a digit number and a decimal value. When the switch is off (towards the number), the decimal
value is 0 (zero). When the switch is on (towards ON and DIP), the decimal value is as follows:
1
Decimal Value
16
•
Add the decimal value of each switch to calculate the address. For example:
1
Status
Off
Binary Value
0
Decimal Value
0
•
Each LΩGIC Wall Controller must have a unique address or the LΩGIC Drive 2X will be unable to respond to any
LΩGIC Wall Controller. The order of addresses does not matter, only that they do not repeat.
Cabling
1
for more details.
10
2
3
4
8
4
2
2
3
4
On
On
Off
1
1
0
8
4
0
INSTRUCTIONS
DIP switches
(upside down)
5
1
5
Total
On
1
01101
1
(0 + 8 + 4 + 0 + 1) = 13
RJ12 with flipped/reverse wiring
DIP switches use
binary addressing
LΩGIC Wall Controller Instructions Rev. 7
Advertisement
Table of Contents
