Table of Contents
Advertisement
2.
Two blanks.
3.
Set console switches as desired.
4.
Depress LOAD CARD, RESET P, AUTO, and START.
If
assembly program 3 is to be run following a DATANET-30 General Assembly Program, the
DATANET-30 Systems Tape must be on tape 1:
1.
Set console switch 7.
This causes assembly program 3 to be read in after completion
of the DATANET-30 General Assembly Program.
2.
Set console switches as desired for proper mode.
3.
Set console switch 6.
This writes the ouput of DATANET-30 General Assembly Pro-
gram on tape 6.
4.
Run the General Assembly Program as previously described.
GENERAL ASSEMBLY PROGRAM 4
General
Assembly program 4 is a magnetic tape generating and updating routine. It may be used to make
the symbolic source tapes input to the DATANET-30 General Assembly Program. Assembly
program 4 is included on the DATANET-30 Systems Tape and may be called in and. executed
with the assembly program 4 call card, or it may be loaded from punched cards.
The minimum systems configuration required is:
1.
8192 words of memory
2.
Typewriter
3.
High- speed printer
4.
Magnetic tape controller with two handlers
5.
Card reader.
Control Cards
The following control cards are used:
NEW
Characters N - E - W punched in columns 8, 9, and 10.
FIN
Characters F - I - N punched in columns 8, 9, and 10.
DEL
Characters D - E - L punched in columns 8, 9, and 10.
A-15
Advertisement
Table of Contents
