Table of Contents
Advertisement
APPENDIX A
DATANET-30 GENERAL ASSEMBLY PROGRAM
DATANET-30 SYSTEMS TAPE
The DATANET-30 systems tape contains the following programs:
1.
DATANET-30 General Assembly Program
2.
General Assembly Program .3 (paper tape conversion)
3.
General Assembly Program 4 {magnetic tape updating).
The programs above are linked together in this order:
1.
General Assembly Program 4
2.
DATANET-30 General Assembly Program
3.
General Assembly Program 3.
To run General Assembly Program 4, it is necessary to call the program from the systems
tape with a "call General Assembly Program 4" card.
The DATANET-30 General Assembly Program may be run:
1.
After General Assembly Program 4 {with SWl and SW16 down)
2.
By itself {using DATANET-30 General Assembly Program call card).
General Assembly Program 3 may be run:
1.
After DATANET-30 General Assembly Program
2.
By itself {using General Assembly Progr.am 3 call card).
General Assembly Program 4 is used to update symbolic source programs.
It
updates magnetic
tape by comparing the sequence number of a card to the sequence number of a record on tape
and inserts the card in the correct position.
[ID&u&~~uc:J ~@------------
A-1
Advertisement
Table of Contents
