Zebra DS9208 - Hands-Free Imager Quick Start Manual
![]()
Overview
![]()
- LED Indicators
- Scan Window
- Scan Trigger
- Beeper
CORD ATTACHMENT
![Zebra - DS9208 - Cord Attachment Cord Attachment]()
WALL MOUNTING
![Zebra - DS9208 - Wall Mounting Wall Mounting]()
TABLE TOP MOUNTING
![Zebra - DS9208 - Table top Mounting Table top Mounting]()
HOST INTERFACES
NOTE: Cables may vary depending on configuration
![Zebra - DS9208 - Host Interfaces Host Interfaces]()
TROUBLESHOOTING
Scanner not working
- No power to scanner
Check system power; ensure power supply, if required, is connected - Incorrect interface cable used
Ensure that correct interface cable is used - Interface/power cables are loose
Ensure all cable connections are secure
Scanner decoding bar code, but data not transmitting to host
- Scanner not programmed for correct host interface
Scan appropriate host parameter bar codes - Interface cable is loose
Ensure all cable connections are secure
Scanner not decoding bar code
- Scanner not programmed for bar code type
Ensure scanner is programmed to read type of bar code being scanned - Bar code unreadable
EnsEnsure bar code is not defaced; try scanning test bar code of same bar code typeure bar code is not defaced; try scanning test bar code of same bar code type - Distance between scanner and bar code incorrect
Move scanner closer to or further from bar code
Scanned data incorrectly displayed on host
- Scanner not programmed for correct host interface
Scan appropriate host parameter bar codes
DS9208 PROGRAMMING BAR CODES
Set Defaults
![]()
Enter Key (Carriage Return/Line Feed)
![]()
USB Host Types
![]()
RS-232 Host Types
![]()
IBM 46XX Host Types
![]()
Keyboard Wedge Host Types
![]()
Scan ONE of the following country types
![]()
OPTIMUM SCANNING
![]()
OPTIMUM ARM POSITION
![]()
AVOID EXTREME WRIST ANGLES
![]()
AVOID BENDING AND REACHING
![]()
BEEPER INDICATIONS
Standard Use
- Low/medium/high beep
Power up - Short medium beep
Bar code decoded - 4 long low beeps
Transmission error detected; data is ignored
- High/low/high/low beep
Successful parameter setting - High/low beep
Correct programming sequence performed - Low/high beep
Incorrect programming sequence or "Cancel" bar code scanned
LED INDICATIONS
Hand-Held Scanning
- Off
Scanner is on and ready to scan, or no power to scanner - Green
Bar code is successfully decoded - Red
Transmission error
Hands-Free (Presentation) Scanning
- Off
No power to scanner - Green
Scanner is ready to scan - Off Momentarily
Bar code is successfully decoded - Red
Transmission Error
123SCAN2
123Scan2 is an easy-to-use, PC-based software tool that enables rapid and easy customized setup via a bar code or USB cable. For more information, visit: http://www.zebra.com/123Scan2.
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Zebra DS9208 - Hands-Free Imager Quick Start Manual
Need Assistance?
Do you have a question about the DS9208 that isn't answered in the manual? Leave your question here.