Advertisement
Set Factory Defaults
The scanner automatically detects the USB host and uses the default setting. If the default (*) does not meet your requirements, scan another host bar code below.
*USB Keyboard HID
IBM Table-Top USB
IBM Hand-Held USB
IBM OPOS
(IBM Hand-Held USB with Full Scan Disable)
Symbol Native API (SNAPI) without Imaging Interface
The scanner automatically detects the RS-232 host and uses the default setting. If the default (*) does not meet your requirements, scan another host bar code below.
*Standard RS-232
ICL RS-232
Wincor-Nixdorf RS-232 Mode A
Wincor-Nixdorf RS-232 Mode B
OPOS/JPOS
Fujitsu RS-232
Scanners using an auto-host detect cable automatically detect the keyboard wedge host and use the default setting. If the default (*) does not meet your requirements, scan the IBM AT NOTEBOOK bar code below.
If using a standard keyboard wedge cable, scan one of the bar codes below.
*IBM PC/AT & IBM PC Compatible
IBM AT Notebook
The scanner automatically detects the IBM host, but there is no default setting. Scan one of the bar codes below to select the appropriate port.
Non-IBM Scanner Emulation (Port 5B)
Hand-Held Scanner Emulation (Port 9B)
Table-Top Scanner Emulation (Port 17)
Add an Enter key after scanned data.
Enter Key (Carriage Return/Line Feed)
Add a Tab key after scanned data.
Tab Key
Override Caps Lock Key (Enable)
*Do Not Override Caps Lock Key (Disable)
Indication | LED |
The scanner is on and ready to scan, or no power to the scanner | Off |
A bar code is successfully decoded | Green |
Transmission error | Red |
Indication | Beeper Sequence |
Power up | Low/medium/high beep |
A bar code is successfully decoded | Short high beep |
Transmission error | 4 long low beeps |
Successful parameter setting | High/low/high/low beep |
Correct programming sequence performed | High/low beep |
Incorrect programming sequence, or Cancel bar code scanned | Low/high beep |
123Scan2 is an easy-to-use, PC-based software tool that enables rapid and easy customized setup of a scanner via a bar code or USB cable.
For more information, visit: http://www.zebra.com/123Scan2.
Indication | Resolution |
Scanner is not working | |
No power to scanner | Check system power |
Scanner is disabled | Ensure that correct host interface cable is used |
Scanner decodes bar code but does not transmit data | |
Host interface not configured properly | Use auto-host detect cable, or scan appropriate host bar codes |
Interface cable is loose | Ensure all cable connections are secure |
Scanner does not decode bar code | |
Scanner not programmed for bar code type | Enable that bar code type |
Bar code is unreadable | Ensure the bar code is not defaced; scan a test bar code of the same bar code type |
Distance between scanner and bar code is incorrect | Move the scanner closer to or further from the bar code |
Scanned data incorrectly displayed on host | |
Host interface not configured properly | Scan appropriate host parameter bar codes |
If you have a problem using the equipment, contact your facility's technical or systems support. If there is a problem with the equipment, they will contact the Support Center at: http://www.zebra.com/support.
For the latest version of this guide go to: http://www.zebra.com/support.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Zebra LS2208 - General Purpose Barcode Scanner Quick Start Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the LS2208 that isn't answered in the manual? Leave your question here.