Playback; Basic Operations - Yamaha HTR-6040 Owner's Manual

PLAYBACK

Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
Before performing operations, set the operation mode selector
(K) to AMP.

Basic operations

1
Turn on the video monitor connected to this
unit.
Press D INPUT l / h repeatedly (or press
2
one of the input selector buttons ( A )) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
Available input source
V-AUX
DVR
INPUT: DVD
Currently selected input source
y
The corresponding input selector button on the remote
control for the currently selected input source lights up for
approximately 5 seconds after you press any buttons on the
remote control, showing which source component is
currently being operated.
3
Start playback on the selected component or
select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 38 for details about FM/AM tuning
instructions.
• See page 41 for details about XM Satellite Radio
tuning instructions.
30
En
Playback
DTV/CBL MD/CD-R TUNER
DVD CD XM
Rotate 8 VOLUME (or press J VOLUME +/
4
–) to adjust the volume to the desired output
level.
Press A PROGRAM l / h repeatedly (or
5
press one of the sound field program
selector buttons ( P ) repeatedly) to select the
desired sound field program.
The name of the selected sound field program appears
in the front panel display.
See page 35 for details about sound field programs.
Movie Dramatic
Currently selected
surround field program
Notes
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically
selects the last sound field program used with the
corresponding input source.
• Sound field programs cannot be selected when the
component connected to the MULTI CH INPUT jacks is
selected as the input source (see page 31).
• When PCM signals with a sampling frequency higher than
48 kHz are input, this unit is automatically set to the
"STRAIGHT" mode (see page 36).
• To display information about the currently selected input
source in the OSD, see page 33 for details.
■ A quick guide to contents
When you want to...
Enjoy pure hi-fi stereo sound
Adjust the tonal quality of the front speakers
Adjust the parameters of sound field programs
Enjoy the sources with a wide dynamic range at night
Use headphones
Select a decoder to play back sources with
Automatically set this unit to the standby mode
See
page
32
32
37
33
34
36
34