FoodSaver VS5910X Reference Manual page 5

Install a FoodSaver Roll
®
See FIG. 1
1. Pull open the built-in roll storage door in the back of the
appliance.
2. Insert the roll into the back of the appliance as pictured.
3. Open up appliance lid fully so that it stays in place.
4. Thread end of roll forward through the opening on the back
between lid and appliance. pull through the appliance until the
end of roll is at the front edge.
5. See next section for how to make a bag from a FoodSaver Roll.
Make a Bag from a FoodSaver Roll
®
(Express Bag Making)
See FIG. 2
1. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
2. Once Roll is installed and appliance lid is fully opened, thread
end of roll forward through the opening on the back between lid
and appliance.
3. Pull roll down just past the Sealing Strip.
4. Using two hands, pull down appliance lid (from the all the way up
position) and with both hands firmly press down both sides of lid
until appliance begins to automatically close and lock.
5. Press Seal Button, sealing the end of the bag will begin. Button
light will pulse until complete and then light will turn off.
6. Appliance lid will automatically open once seal is complete.
7. Pull out now sealed end of roll to length of bag desired.
8. Again, using both hands firmly press down both sides of lid, until
appliance begins to automatically close and lock.
9. Before using cutter bar to cut this first bag, press Seal Button to
seal end of next bag.
10. While appliance is sealing the next bag, cut first bag by sliding
the built-in Cutter Bar.
TIP: After making this first bag from the roll, if the above steps are
followed, the seal should already be made for the next bag. Each time
you seal, you are making the seal for the next bag while using cutter
bar to cut the current bag.
11. After finished making bag(s) from roll, open built-in roll storage
door in the back of appliance and manually roll up the excess roll
that may still be inside the appliance, so that no roll or material is
left inside the appliance.
12. Close Built-in Roll Storage and Door.
7 www.foodsavereurope.com
VS5910X_23MLM1 (EMEA).indd 7-8 VS5910X_23MLM1 (EMEA).indd 7-8
Vacuum Seal with FoodSaver Bags
®
See FIG. 3
1. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
2. With both hands, slowly insert the open end of filled bag through
the bottom of the Vacuum View Window into Drip Tray.
NOTE: The appliance lid should Not be completely open.
HINT: If having trouble getting bag inside appliance, wiggle it from
side to side while inserting.
IMPORTANT TIP: When inserting open end of filled bag, center the
bag in the middle of the appliance for best results. The Vacuum View
Window allows you to easily see where the end of the bag is when
inserting. Continue to insert and hold bag until appliance automatically
detects and lid closes and locks.
3. The appliance will automatically detect bag insertion & Appliance
Lid close and lock. Bag Detected indicator light will blink then
become steady to confirm the bag has automatically been
sensed. Vacuum and Seal Button Lights will blink.
CAUTION: Lid closes down automatically. Remove hands or any
other objects that may be obstructing the lid before closing. Do not
manually force the lid to close.
4. Select desired Vacuum Mode (Dry, Moist, Liquid, or Sous Vide)
depending on the food that is being vacuum sealed by pressing
Mode Button. Indicator light will illuminate next to selected mode.
5. Once desired mode is selected, press Vacuum Button to begin
vacuum sealing process. Vacuum Button light will pulse until
complete.
6. After vacuum is complete, Vacuum button light will go steady and
appliance will automatically begin sealing. Seal Button light will
pulse until complete.
7. Once vacuumed and sealed, vacuum and seal button lights will
go steady then turn off. Appliance lid will automatically open and
release the bag.
8. Refrigerate, freeze or store as needed. (See "Guidelines" for
food storage safety tips on pg 9.)
IMPORTANT TIP: At any time during vacuum sealing, the Cancel
Button can be pressed and the appliance lid will open automatically.
When Dry and Moist lights flash, the drip tray is full. Please empty
it. Vacuum and Seal function will function normally after drip tray is
emptied.
Use FoodSaver Preserve & Marinate
®
Containers
To Vacuum Seal
See FIG. 4
1. Prepare accessory according to FoodSaver Accessory
®
Guidelines, included with accessory purchases.
2. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
3. Pull out the Built-In Retractable Handheld Sealer to desired
length.
CAUTION: When pulling hose Do Not extend beyond red line marked
on hose.
4. Place end of Built-In Retractable Handheld Sealer over container
valve.
5. On right side of appliance press Mode Button for Built-In
Retractable Handheld Accessory once. Vacuum Mode is the
default. Vacuum Mode indicator light will illuminate and Handheld
button will blink.
6. Press Handheld Button to begin vacuum. Appliance lid will
automatically close. Hold Handheld sealer in place on container.
Handheld Button light will pulse until complete.
7. Appliance will automatically stop vacuuming once all air has been
removed from container and Appliance Lid will automatically
open.
8. To put Handheld sealer back in appliance, gently pull out & it will
automatically retract.
IMPORTANT TIP: At any time during vacuum sealing, the Cancel
Button can be pressed and the appliance lid will open automatically.
IMPORTANT: When placing Retractable Handheld Accessory back in
appliance, ensure it is placed right side up and not up side down.
To Marinate
See FIG. 5
1. Prepare accessory according to FoodSaver Accessory
®
Guidelines, included with accessory purchases.
2. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
3. Pull out the Built-In Retractable Handheld Sealer to desired
length.
CAUTION: When pulling hose Do Not extend beyond red line marked
on hose.
4. Remove clear bottom portion of Retractable Handheld Sealer
from top handle by pulling apart with two hands. Insert the tip of
the top half into container valve.
5. On right side of appliance press Mode Button for Built-In
Retractable Handheld Accessory two times for Marinate Mode.
Marinate Mode indicator light will illuminate solid and Handheld
button will blink.
6. Press Handheld Button to begin. Appliance lid will automatically
close and begin marinating process. Appliance lid will
automatically open during process and then close and lock
again. Handheld Button light will pulse until complete.
7. Reconnect the bottom of Handheld Sealer and to put Handheld
sealer back in appliance, gently pull out & it will automatically
retract.
IMPORTANT TIP: Appliance will run for about 12 minutes. The
appliance will vacuum, then stop vacuuming & appliance lid will open,
then close again and begin vacuuming a total of 3 times. Do not
interrupt this process, even if you think that appliance has canceled.
IMPORTANT TIP: At any time during vacuum sealing, the Cancel
Button can be pressed and the appliance lid will open automatically.
IMPORTANT TIP: During marinating, ensure the handheld accessory
hose stays clear of lid (When appliance lid opens and closes during
marinating, do not let the hose get caught in between lid and
appliance.)
www.foodsavereurope.com
Vacuum Seal with FoodSaver
®
Accessories
For Zipper Bags
See FIG. 6
1. Fill zipper bag, lay flat with grey circle facing upwards. Squeeze
air out, zip 3/4 of the way closed and squeeze any remaining air
out before zipping completely.
2. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
3. Pull out the Built-In Retractable Handheld Sealer to desired
length.
CAUTION: When pulling hose Do Not extend beyond red line marked
on hose.
4. Place end of Built-In Retractable Handheld Sealer over zipper
bag valve.
5. On right side of appliance press Mode Button for Built-In
Retractable Handheld Accessory once. Vacuum Mode is the
default. Vacuum Mode indicator light will illuminate and Handheld
button will blink.
6. Press Handheld Button to begin vacuum. Appliance lid will
automatically close. Hold Handheld sealer in place on bag.
Handheld Button light will pulse until complete.
7. Appliance will automatically stop vacuuming once all air has
been removed from zipper bag and lid will automatically open.
8. To put Handheld sealer back in appliance, gently pull out & it will
automatically retract
IMPORTANT TIP: At any time during vacuum sealing, the Cancel
Button can be pressed and the appliance lid will open automatically.
IMPORTANT: When placing Retractable Handheld Accessory back in
appliance, ensure it is placed right side up and not up side down.
For Jar Sealers & Bottle Stoppers
See FIG. 7
1. Prepare accessory according to FoodSaver Accessory
®
Guidelines, included with accessory purchases.
2. Press Power Button to turn appliance on. Power button and
default mode selection will illuminate.
3. Pull out the Built-In Retractable Handheld Sealer to desired
length.
CAUTION: When pulling hose Do Not extend beyond red line marked
on hose.
4. Remove clear bottom portion of Retractable Handheld Sealer
from top handle. Insert the tip of top into the port on the Jar
Sealer or Bottle Stopper.
5. Repeat steps 4-8 above.
NOTE: FoodSaver Jar Sealers are for use with Ball and Kerr brand
® ® ®
Mason jars only. This is not a replacement for traditional canning
methods and if food is perishable will need to be refrigerated.
IMPORTANT TIP: Do not include screw bands when vacuum sealing
jars. To open, wedge spoon between Mason jar lid and highest part
of threaded rim. Twist spoon gently to release vacuum. FoodSaver
®
Bottle Stoppers: To release vacuum and open, twist and pull up on
Bottle Stopper.
2023/10/24 10:17 2023/10/24 10:17
8