Table of Contents
Advertisement
WARNING:
WHAT TO DO IF YOU SMELL GAS
• Do not light any fireplace.
• Do not touch any light switch
• Do not use any phone in your building.
• Call your gas supplier from a neighbor's phone.
• Follow the provider representative's instructions.
• If you cannot reach your gas supplier, call the fire
department for assistance.
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing
property damage, personal injury, and loss of life.
SAFETY INFORMATION
• This fireplace is equipped with an ignition device
which automatically lights the pilot. Do not attempt
to light pilot by hand.
• Before operating, smell all around the area for gas.
Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
• Toggle master switch to on. The burners will not ignite
unless the master switch is on.
• Use only the supplied remote control to light the
pilot. This valve will not operate if the pilot is not lit
and stable.
• Do not use if any part has been underwater.
Immediately call a qualified service technician to
inspect and replace any component which has
been under water. Attempted operation may result
in fire or explosion resulting in property damage,
personal injury, and loss of life.
OPERATING INSTRUCTIONS
1. Read the above safety information carefully before
proceeding.
First-Time Lighting Instructions
2. Do not attempt to light the pilot by hand; the door
must remain on this fireplace during pilot ignition,
except for the first time lighting.
3. Press the On/Off button on remote control to begin
the ignition sequence.
4. There will be an audible beep and then the igniter
will begin to spark. After the pilot lights and is
established, the valve will automatically open and
the burner will light. The burner will initially light to
full flame. Adjust it to an appealing setting with the
remote (see "Remote Operating Instructions" in this
manual).
WARNING: If the pilot fails to light, the system will
"lockout". Press On/Off button on remote control to
turn off the system. Allow five minutes for any gas to
dissipate before attempting to re-light the pilot.
5. Press On/Off button on remote control again to
start ignition sequence.
6. If it will not operate, follow the instructions "Turning
Off" section and call your service technician or gas
supplier.
TURNING OFF
1. Press the On/Off button on the remote control.
2. Turn off the external manual shutoff valve supplied
by installer and mounted adjacent to the fireplace.
3. Turn off all electric power to the fireplace if service
is to be performed.
-22-
Advertisement
Table of Contents
