Test Run - Grizzly G0453ZX Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the machine disabling safety feature functions
properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
Clear all setup tools and loose objects away
1.
from machine.
Move POWER switch to OFF position.
2.
-22-
G0454X Only: Push STOP button in.
3.
Connect machine to power supply.
4.
Move POWER switch to ON position
5.
G0454X Only: Twist STOP button clockwise
6.
until it springs out (see Figure 17). This
resets switch so machine can start.
Figure 17. Resetting switch.
Press green START button to turn machine
7.
ON. Verify motor starts up and runs smoothly
without any unusual problems or noises.
Press STOP button to turn machine OFF.
8.
G0453X Only: Remove switch disabling key,
9.
as shown in Figure 18.
Figure 18. Removing switch key from paddle
switch.
Model G0453ZX/G0454ZX (Mfd. Since 01/24)