Troubleshooting - Dometic TWIN EAGLES TE 24F Installation And Operating Manual

Outdoor fridge
Hide thumbs Also See for TWIN EAGLES TE 24F:
Table of Contents

Advertisement

Available languages

Available languages

11 Troubleshooting

Problem
The device does not work.
The device is not cold enough.
The device switches itself on and off.
The interior LED lamp does not work.
Possible cause
The device is not connected to a pow-
er supply.
The device is switched off.
The circuit breaker tripped.
The fuse has blown.
The temperature is not set properly.
The ambient temperature could re-
quire a higher temperature setting.
The door was opened frequently.
The door was not closed properly.
The door is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked.
The room temperature is higher than
specified in the technical data (see
Technical
data).
The device was recently replenished
with new food.
The door was opened frequently.
The door was not closed properly.
The door is not hermetically sealed.
The device is not connected to a pow-
er supply.
The circuit breaker tripped.
The fuse has blown.
The interior LED lamp was switched off
via the control panel.
TE 24F (EA 24F), TE 24D (EA 24D)   EN
Suggested remedy
Connect the device (see
necting the device to the power
supply).
Switch the device on (see
ing the device
Switch on the circuit breaker.
Replace the fuse.
Check the set temperature.
Set a higher temperature (see
Setting the
Do not open the door more of-
ten than necessary.
Close door properly.
Check the door seal and clean it.
If necessary, contact an autho-
rized service agent to replace
the seal.
Clean the condenser.
Clean the ventilation openings.
Put the device in a cooler place
(see
Moving the
Allow the device to work for a
while until the set tempera-ture
has been reached.
Do not open the door more of-
ten than necessary.
Close door properly.
Check the door seal and clean it.
If necessary, contact an autho-
rized service agent to replace
the seal.
Connect the device (see
necting the device to the power
supply).
Switch on the circuit breaker.
Replace the fuse.
Switch on the interior LED lamp
(see
Switching the light
Con
Switch
on/off).
temperature).
device).
Con
on/off).
19

Advertisement

Table of Contents
loading

Table of Contents