Dometic TWIN EAGLES TE 24F Installation And Operating Manual page 15

Inserting the shelf supports
Proceed as shown.
Fig.  on page 6
Inserting the shelves
Proceed as shown:
TE 24F:
Fig. 
Selecting the installing location
WARNING! Risk of injury
Move the device with at least 2 people.
• The intended ambient temperature and the cli-
mate class can be found in the technical data (see
Technical data) and on the data plate of the de-
vice.
• The ground must be level and sufficiently stable to
support the device when fully loaded.
• The device must be positioned so that the plug is
accessible.
• Note the information on the electrical connection
(chapter Connecting the device to the power sup
ply).
• Do not install the device in an area with excessive
moisture.
• Remove all the inner and outer packaging material
before setting up the device.
Placing the device
NOTE
• Observe the device's dimensions
(Technical
(Fig. ) when installing the device.
• Ensure that the door can be opened
completely and is not blocked by other
objects.
Fig.  on page 7
TE 24F
1. Ensure that the door is locked when moving the de-
vice.
2. If necessary, tape the door with duct tape.
on page 6
data) and safety distances
TE 24F (EA 24F), TE 24D (EA 24D) EN
3. Position the device.
EA 24D only
1. Fix the drawers with duct tape when moving the
device.
2. Attach the anti-tip brackets on the floor.
Fig.  on page 8
3. Position the device.
Connecting the device to the power
supply
NOTICE! Damage hazard
• Do not modify or damage the plug.
• Do not plug the device in an socket
that can be turned off by a switch or
pull chain.
• To avoid voltage drops and loss of per-
formance do not use adapters, exten-
sion cords, or power strips.
• Ensure that an residual current circuit
breaker is installed to the power sup-
ply. Seek advice from a trained electri-
cian.
• Observe the input voltage (see
cal data).
NOTE Let the device stand upright for 24 h
before connecting it to the power supply.
Plug the device into a AC socket.
Adjusting the feet
NOTE The bottom of the device must be
horizontal.
Ensure the device is level by adjusting the feet.
Fig.  on page 8
Adjusting the shelves
Adjust the shelves.
Fig.  on page 9
Techni
15