Midea MDF24P1AST Installation Instructions Manual page 32

4. Using two Phillips-head screws (provided), fasten the two mounting
clips on the top of the dishwasher to the underside of the countertop.
5. Open the door about 3" (7.6 cm) and check that the space between
the inner door and tub is equal on both sides.
6. If spacing is not equal, loosen the mounting clip screws and shift the
tub. Retighten bracket screws.
7. Check that the top of the door does not contact the screws, mounting
clips or countertop. If it does, the dishwasher must be lowered and
leveled again. See "Level The Dishwasher."
NOTES
•
Drive the screws straight and flush. Protruding screw heads will
scratch the top of the control panel and can interfere with door
closing.
•
If spacing is not equal, loosen the bracket screws and shift the tub.
Retighten the bracket screws.
8. Remove towel from dishwasher.
9. Reinstall the lower dish rack.
Method 2 - Installation to Adjacent Cabinets
Secure the dishwasher to the adjacent cabinets using the side mounting
brackets.
1. Open the dishwasher, remove the lower dish rack, and place a towel
over the filters, located at the bottom of the tub, to prevent debris
from falling into the pump system.
Insert a mounting clip into the slot (one on each side) of the
2.
32
dishwasher.
Open the dishwasher door. Using a flat-blade screwdriver or prying
3.
tool, remove the hole covers (one on each side).
Insert the screws through the dishwasher side-mount bracket and into
4.
the adjacent cabinet on each side.
a
#8 x
Flat-head
Screw
a
5/8
" Phillips