Kenwood KR-A5040 Instruction Manual page 7

Speaker connections
10mm @ @
eae Remove insulation:n Twist wire tightly
a from lead tip. and solder.
@ % ®
Raise the lever. Insert the wire and The wire is
return the lever. now locked.
Speaker lead connection
M@ Setting the speaker IMPEDANCE SELECTOR
When connecting one pair of speakers to the SPEAKERS A or
B terminals, set the IMPEDANCE SELECTOR according to the
speaker impedance. . = e
When two pairs of speakers are connected to both the A and
B terminals, match the speaker impedance selector to the
speakers with the lowest impedance.
Notes: —————_______—____ —
1. During speaker system connection and operation of the speak-
er IMPEDANCE SELECTOR, set the POWER switch to OFF.
2. Check that the connected lead wires of the speaker systems
do not contact with other jacks or terminals.
When using the speaker A or speaker B separately
A OR B: (BELOW 8Q) io]
80, 160 : (8Q OR MORE) !
When using the speakers A and B simultaneously
A AND B: (8@ OR MORE}
Speaker impedance
82, 160
IMPEDANCE
SELECTOR
LESS THAN 82 OR
82 a. MORE
@ Connecting the speakers
Connect speakers rated at 4 ohm or more to the SPEAKERS
terminals.
1. Connect the left speaker to the L speaker terminals on
the rear of the receiver and the right speaker to the R
terminals.
2. Connect each cable as shown in the illustration, taking
care that the wires do not make contact with other ter-
minals.
Notes:
1. Take cara so as not to short the positive {+) and negative {—)
speaker cords.
2. If the left and right speakers, or positive and negative cables,
are connected the wrong way, the reproduced sound may be
unclear, with ambiguous location of the musical instruments etc.
To avoid this, pay attention to the left and right and positive
and negative indications when connecting the speakers.
@ AC outlets
The AC outlets on the rear panel may be used to supply pow-
er to other components in the system, such as turniables, tape
decks, etc. Never connect equipment whose power consump-
tion exceeds the maximum value shown at each ouilet.
SWITCHED ouilets:
The maximum total capacity is 200 waits, 1.6 A max.
Unit destination Shape of the AC outlet
ee
Other countries
WARNING
Particular attention must be given to making good elec-
trical contact at the receiver output and speaker ter-
minals. :
Poor or loose connections can cause sparking or burn-
ing at the terminals because of the very high power that
the receiver can deliver.
KR-A5040 (En) 7