Kenwood KR-A5040 Instruction Manual page 14

Listening to broadcasts
POWER key
KENWOOD AM-FM STEREO RECEIVER KR-ASOSO
Numeric keys
Input selector keys
@ To listen to radio broadcasts
1. Press the POWER key to ON.
2. Prass the TUNER input selector key.
3. Press the BAND selector key to select FM1, FM2 or AM.
@ Every time the BAND selector key is pressed, the receiv-
ing band is switched in order:
[' FM1 —4- FM2 +> AM 7
BAND selector key VOLUME CONTROL knob
AUTO key
VOLUME SONTROL
afd 'Bim ,.
TUNING key
4. Tune in the desired broadcasting station according to the
instructions in the''Tuning methods''section below.
® During tuning, sound is not heard because the muting
circuit is activated. The sound will be heard suddenly as
soon as a station is received, so be careful in setting the
sound volume level.
5. When the desired station is received, adjust the volume
with the VOLUME CONTROL knob.
@ Tuning methods
Auto tuning
When the TUNING key is pressed, broadcast frequencies are
scanned automatically in the upward or downward direction
unti! a station is located and tuned in. The stereo/monaural FM
reception mode is set automatically according to the station.
1. Press the AUTO key so that the AUTO indicator lights.
2. Press the ~ (UP) or V {DOWN} segment of the TUNING
key.
®@ Press the " (UP) segment scans broadcast frequencies
by varying the displayed frequencies in the upward direc-
tion, and pressing the v (DOWN) segment scans by
varying the frequencies in the downward direction.
@ When a broadcasting station is received, the frequency
display freezes and indicates the frequency of the
received station.
3. If the received station is not the desired station, press
the same segment of the TUNING key again.
@ Repeat this unit ihe desired station is received.
JQ xR-45040 (En)
Manual tuning
Stations with weak signal strength cannot be received by auto
tuning. In such cases, tune in the desired station by manual
tuning. The station will be received in monaural mode
(monaural mode is resistant to noise}. —
1. Press the AUTO key so that the AUTO indicator is off.
2. Press the " (UP) or V (DOWN) segment of the TUNING
key.
@ Every time the TUNING key is pressed, the displayed fre-
quency varies by one step in the direction indicated by
the pressed segment.
@ Holding the TUNING key depressed varies the displayed
frequency continuously.
3. When the frequency of the desired station is tuned in,
release the TUNING key.
@ Noise may be heard if the tuned frequency is not pre-
cisely the same as the frequency of the station. In such
cases, press the " (UP) or Y (DOWN) segment of the
TUNING key to adjust the tuning precisely.