Kenwood KR-A5040 Instruction Manual page 12

Operating instructions
POWER key
POWER ON/
STAND BY
indicator
KENWOOD AM-LFM STEREO RECEVER KA A50sC
PHONES jack
TREBLE control knob
BASS contro! knob
@ Basic operation
1. Press the POWER key to ON.
@ The display lights, the point indicator blinks for about 5
seconds then lights steadily, and the unit becomes
operative.
@ Pressing ihe key again switches the power OFF.
2. Press one of the Input selector keys to select the input
source to be played.
@ If a System Control cord has been connected to the
selected source component, it starts play automatically
due the Automatic Play operation feature.
® With the Automatic Play operation feature, when one
of the source components is started to be played, the
corresponding input selector is automatically switched
for the source.
®@ The selected input source is shown on the display.
3. If automatic play operation using the System control
cords has not been set, start playing the source compo-
nent selected.
4. Adjust the output level with the VOLUME CONTROL knob.
5. Adjust the balance of the left and right output levels with
the BALANCE contro! knob.
6. Adjust the tone (BASS, TREBLE) for your preference.
Note: -—
When the TAPE-2 selector switch is set to ON, the input source
selected with the input selector keys cannot be heard from the
speakers. To listen to a source other than tape deck 2, be sure to
set the TAPE-2 selector key to OFF.
42 kR-A5040 iEn)
ee ee ee ee ee ee ee
—_——— oo —
input selector keys
VOLUME CONTROL knor
VOGLUME CONTROL
1B
wit im,
MEMORY BAND DIRECT
—
LOUBNESS switch . BALANCE control kneb
Point indicator
Hi Principal key function
Tone control knobs (BASS) {TREBLE)
Adjust tone controls to suit your taste.
BALANCE control knob
If an imbalance occurs (the left or right channel appears loud-
er than the other} due to source imbalance or room acoustics,
adjust BALANCE control to equalize tne sound from both
speakers.
LOUDNESS switch .
If you customarily listen at low listening levels, set the
LOUDNESS switch to ON. If not, set it to OFF position.
POWER STAND-BY indicator
This indicator lights if the power cord is plugged into the AC
outlet, It is lit to show that the POWER switch on the front panel
or the POWER key on the remote control unit can be activated.
PHONES jack
This jack accepts the standard stereo headphone plug.
When you wish to listen through headphones alone, set the
SPEAKERS switches {A and B} both to the OFF (1) pasition.