Advertisement
6.
Locate the hardware for the Stab and Rudder.
Installing control horns: All of the control horns on your aircraft install in the same way. Locate the cor-
rect control horn for each surface. Prep the horns by lightly scuffing the gluing area (the part which will
go into the control surface) with sandpaper or an emery board. Test fit the horn without glue to make
sure it goes all the way into the surface as shown. To permanently install the horn, place medium CA
glue into the slot, insert the horn fully and firmly into the slot, and then add a few drops of thin CA.
The 84"Bushmaster can be flown as a gentle sport flyer, or a high power STOL/3D plane. For slower
flight, it can use smaller servos, and the servo openings in the kit are 33mm long. To fit higher perfor-
mance servos such as Savox 1261 or Theta 989, open the servo locations to 35mm long.
Advertisement
