Advertisement
7.
Using epoxy glue, mount the stab fences to the ends of the horizontal stabilizer as shown.
Optional Step: Included in your kit are two balsa pieces which can be used as fillers by installing with
CA glue behind the elevator. To color match these panels, your kit includes spare covering sections,
also useful for small repairs.
Install the elevator servo as shown, running the extension for the servo through the fuselage and using
tape or a plastic clip to prevent the extensions from becoming unplugged in flight. Thread the rudder
cables through the slots on either side of the vertical stabilizer/rudder and into the fuselage as shown.
Run the cables forward, crossing them once to form an X shape inside the fuse. Assemble the cable
ends as shown, crimping the crimp tubes with pliers and adding a drop of thin CA. Install the rudder
servo, assembling the arm with cable ends and tailwheel pushrod as shown. Note that the tailwheel
pushrod connector should be left loose enough to rotate freely in the arm and a drop of medium CA
locks the nut in place.
Advertisement
