Advertisement
8.
Tape the rudder as shown to hold it straight while you assemble the cables at the rear. Assemble
the cable ends as shown onto the rudder horns. Pull the cables taut and through the crimp tubes
and crimp as shown. Add a drop of thin CA to the crimp. Thread the cable ends into the ball links
to tighten the cables as needed. The goal is no sag and no play, but it's not necessary to make them
"bajo string" tight.
Scuff the recesses on the cowl, and the ends of the turbine exhaust pipes, and glue in place with
epoxy. Tape as necessary while the epoxy cures. Attach your brushless motor to the motor box with
loctite, here we are showing the installation of the recommended T-Motor AM600.
Advertisement
