Table of Contents
Advertisement
Checking the Wired remote controller PCB
Settings
In order to check the DIP switch settings using the wired remote
controller, hold down the
time for 5 seconds.
1
The menu will display .
Press the
button until
2
Press the
button.
Check the DIP switch value of the wired remote controller.
Value
Switch OFF
Switch ON
3
To change the page, press the
Page No.
Set value of DIP switch 1~4
Set value of DIP switch 5~8
4
Press the
button to exit.
You will move to the menu selection display.
Note
Press the
without setting.
and
buttons at the same
is displayed.
Data
buttons.
Data
button anytime during setup to exit
Menu No.
Page No.
DIP Switch No.(1~4)
Menu No.
Page No.
DIP Switch No.(5~8)
29
E-
Advertisement
Table of Contents
