Mig Process; Mma Process - Cebora SYNSTAR Installation And Quick Manual

7

MIG PROCESS

For all the processes indicated below (except for MIG Manual), the welding parameters are adjusted synergically using knob 2. Individual
processes are available only for the individual synergic curves for which they have been developed or which are allowed by the process.
8

MMA PROCESS

Select the MMA process
Beware of electrical shocks
When the main switch is in ON position, the electrode and the non-insulated part of the electrode holder are live. Therefore, make sure that the
electrode and the non-insulated part of the electrode holder do not come into contact with electrically conductive earthed persons or components
(e.g. outer casing, etc.).
3301292/A
MIG Pulse. When this welding process is selected, the filler material is transferred via a controlled
energy pulsed waveform to achieve constant detachment of molten material droplets that are
transferred to the workpiece without spatter. The result is a strip of molten welding material that joins
any material thickness or type effectively, with no spatter on the workpiece.
MIG Short. When this process is selected, the material can be transferred in different ways: Short Arc,
Globular, Spray Arc and it depends on the ratio between wire speed and set welding voltage.
MIG Manual. After selecting MIG Manual, select the type of wire, diameter and
gas from the main menu. Select the m/min and set the motor speed, selecting the
welding voltage. Press knob 2 for longer than one second. The voltage for the m/
min set will be shown on the display. Now the m/min can be increased without
changing the voltage.
WARNING
25