Table of Contents
Advertisement
Command
FD
REBOOT
PWn
Where:
n = 0 = Output Blanked, all LEDs off
n = 1 = Output On, Selected input active
Operation
Web GUI Operation
As shipped from the fctory (or after factory default reset), the SW-HD-4A IP address is set for a static IP
address of 192.168.0.88 and a static GW (Gateway) address of 192.168.0.1.
Use RS-232 terminal software to find the currently assigned IP and GW addresses (and to also set them
as desired).
SW-HD-4A internal Web pages (Web GUI)
o Access the SW-HD-4A Webpage with any compatible browser at the IP address found above.
The browser will open with the devices Switch Info tab displayed.
Click the tabs at the top of the screen to access the other tabs.
o Switch Info Tab
▪ INPUT 1 thru INPUT 4
• Shows the currently selected HDMI input.
• Click the desired INPUT button to select that HDMI input.
▪ The following information is also shown.
• HDMI Input Status (ON or OFF)
• HDMI HDCP Input State (None, HDCP 1.4 or HDCP 2.2)
• Resolution
• Pixel Clock
Hall Technologies
August 9, 2023
Response
Factory Default
Factory Default
SW-HD-4A
V1.0
REBOOT
Reboots the unit
SW-HD-4A
V1.0
PWn
Simulates a power condition
Where:
n = 0 = Output Blanked, all LEDs off
n = 1 = Output On, Selected input active
Function
Page 10 of 16
Advertisement
Table of Contents
