Table of Contents
Advertisement
Configuration
•
Connect all video sources to the VIDEO IN connectors.
•
Connect the display device to the OUTPUT connector.
•
Connect the Power Supply to the power input.
•
Connect any external controller or PC to the RS-232 terminal block, if required.
•
Connect IP-CTRL port to compatible LAN network, if required.
•
Connect IR detector to external IR CTRL port, if required.
Operation
The unit can be controlled via front panel and via external control options like IR remote control, RS-
232, Telnet and/or the Web GUI.
• Press the desired INPUT button switch to display the available video on the HDMI output.
• The illuminated LED shows which input is directed to the OUTPUT connector.
• Press and hold INPUT button #1 for 7 seconds, then release to factory reset the unit to default
settings.
• Press and hold INPUT button #4 for 7 seconds to start cycling through each input at a 1-minute rate
• Press and hold INPUT button #4 for 11 seconds to stop cycling through each input.
• The USB port can be used for firmware upgrades or powering external devices.
• The IR remote control supplied with the unit can be used to select the desired HDMI INPUT, MUTE
the HDMI OUTPUT audio or turn the system on or off (Unit will always be ON after a power cycle).
Hall Technologies
August 9, 2023
Page 7 of 16
Advertisement
Table of Contents
