Table of Contents
Advertisement
(LGVOZ
"ON)
VL-L
How to Use the Remote Control
The Remote Control makes it easy to control many of the functions of the CA-S30BK from a distance of up
to 6m away. You need to point the remote sensor at the CA-S30BX front panel.
() Most of the buttons on the Remote Control do just what the ones on the CA-S30BK do.
C) A few functions are available only by using the Remote Control, and those are described below,
Q1 The buttons whose names or marks are printed in blue can be used for the Onc Touch Operation.
Using the 10 Key Pad
The 10key pad is used to specify aCD track or the number you have assigned to a preset radio station. To enter i a number
using the 10 key pad follow these steps:
© Before using the 10 key pad, make sure which the 10 key pad functions for, the CD player or tuner.
This is depends on which button on the Remote you have pressed before 10 key pad. For example, if you press
AM or FM before 10 key pad, it can select a preset station. If you press ® for the CD player, it can select a CD
track.
Q) For numbers between | and 10, just press the button with the number you want.
O For numbers from #1 to 20, first press the +10 key, then the one' § digit of the number you want — to get (5, first
press +10, then 5, For 20 press + 10 and 10.
O) For numbers from 21 to 30, press the +10 key twice; then press the one's digit — to get 25, press +10 +10 and
5 . For 30, press + 10 +10 and 10
Q Fer numbers from 31 to 40, follow the same procedure, only press the +10 key three times, then the one's digit
— to get 32, press +10 +10 410 and 2.
;
FM MODE/MUTE
Select radio reception mode
sce page 9
SOUND MODE
Select the sound mode
Turns power On or Off
sce page 7
Sct the sound effects
Activate the keypad for
entering track numbers,
Sce description above
Controt CD Player
Select tuner or auxiliary
equipment
Control deck B
Control deck A
Press to automatically
reduce volume when
changing from one
source to another, or
turning the CA-S30BK
on from a distance
Volume up and down
Page 20
Care and Maintenance—General Notes
Compact Discs
Handle your compact discs, cassette tapes, and tape deck carefully,
and they will jast a long time.
«
Remove the CD from the case by
holding it at the edges while pressing
the center hole lightly.
*
Do not touch the shiny surface of the
CD, or bend the CD,
*
Place the CD into the open tray with
the label facing up.
*
Putthe CD back in its case after use
lo prevent warping.
* Be careful not to scratch the surface
of the CD when placing it back in the
casc.
*
Avoid exposure to direct sunlight,
temperature extremes, and moisture.
*
Adirty
CD may not play correctly. If
a CD does become dirty, wipe it with
s
a soft cloth: in a straight fine from
center to edge.
CAUTION: Do not use any solvent (for example, conventional
record cleaner, spray, thinner, benzine, etc, a lo Pel n a es
On Moisture Condensation
Moisture may condense on the lens inside
the unit in the following cases:
* After starting the heating in ihe room.
«Ina damp room.
+ If the unit is brought directly from a
cold to a warm place.
Should this occur, the unit may malfunc-
tion. in this case, leave the unit turned on
for a few hours until the moisture evapo-
rates, unplug the AC powercord, and then
plug it in again.
In general, you will have the best performance by keeping your
tapes, CDs, and the mechanism clean.
Store tapes and CDs in their cases, and keep them in cabinets or
on shelves.
Keep the tape deck tape carriers and the CD tray closed when not
in use,
Page 21
Cassette Tapes
«
Ifthe tape is loose in its cassette, take
up the slack by inserting a pencil in
one of the reels and rotating,
+
[fthe tape is loose, it may get stretched,
cut, or caught in the cassette,
*
Do not touch the tape surface.
*
Do not store the tape:
-
Endusty places
-
Indirect sunlight or heat
-
In moist areas
Ona TY of speaker
-
Neara magnet
Tape Deck
If the heads, capstans, and pinch-roflers of the tape deck become
dirty, the following will occur:
-
kmpaired sound quafity
-
Discontinuous sound
-
Fading
-
Incomplete erasure
-
Diffieully recording
Clean the heads, capstans, and pinch-rotlers using a cotton swab
moistened with alcohol.
pinch-rollers
capstans
if the heads become magnetized, it will produce noise or loose
high frequencies.
To demagnetize the heads, turn off the Unit, and use a head
demagnetizes (available at electronics and record shops).
NAOES-VO
Advertisement
Table of Contents
