Philips sonicare DiamondClean 9000 Series Manual page 20

20
English
Cleaning
Toothbrush handle
Brush head
Charger
Travel case
Charging travel case
Note: When the battery is completely empty, the
toothbrush switches off. Place the toothbrush on the
charger to charge it.
Note: To keep the battery fully charged at all times, you
may keep your toothbrush on the charger when not in
use.
1 Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
1 Rinse the brush head and bristles after each use.
2 Remove the brush head from the handle and rinse the
brush head connection with warm water at least once
a week. Rinse the travel cap as often as needed.
1 Unplug the charger before you clean it.
2 Wipe the surface of the charger with a damp cloth.
Rinse with warm water and use a damp cloth to clean
inside of travel case.
1 Unplug the charging travel case before cleaning.
2 Use damp cloth to wipe the surface of the travel case.