Philips sonicare DiamondClean 9000 Series Manual page 12

12
English
45°
BrushPacer
2
1
3
4
6
5
Modes
4 Gently keep the bristles placed on the teeth and in the
gumline. Brush your teeth with small back and forth
motion so the bristles reach between the teeth.
Continue this motion throughout your brushing cycle.
Note: The bristles should slightly flare. It is not
recommended to scrub as you would with a manual
toothbrush.
Note: If you apply too much pressure, you will be
alerted by a change in vibration of the handle and the
brush head replacement reminder flashing amber.
5 To clean the inside surfaces of the front teeth, tilt the
brush handle semi-upright and make several vertical
overlapping brushing strokes on each tooth.
6 After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces
of your teeth and areas where staining occurs. You
can also brush your tongue, with the toothbrush
switched on or off, as you prefer.
Note: Your Philips Sonicare toothbrush is safe to use on
braces (brush heads wear out sooner when used on
braces) and dental restorations (fillings, crowns, veneers)
if they are properly adhered and not compromised.
To make sure you brush evenly throughout the mouth,
divide your mouth into 6 sections using the BrushPacer
feature. The BrushPacer divides the brushing time into 6
equal segments and indicates when you should move to
the next area. The segments are indicated with a brief
pause in vibration. The toothbrush automatically stops at
the end of the brushing session.
Note: Additional segments may be added when you use
the White+ or Gum Health Modes.
Your power toothbrush is equipped with 4 different
modes: Clean, White+, Gum Health and Deep Clean+.
Based on the smart brush head you use, the optimal
mode and intensity will be selected automatically by the