Table of Contents
Advertisement
SET Function
Choosing a scene (SET function)
You can put a scene into the editing program by
pressing the FLEXIZONE AE button at point where
you want the scene to start and at the point where
you want it to end. (The "cut-in" and the "cut-out"
points.)
Instead of using the controls on the camcorder
body, you can use the wireless controller. The
EXECUTE button on the wireless controller
corresponds to the FLEXIZONE AE button on the
camcorder. The four arrows on the wireless
controller correspond to the FlexiZone controller.
1. Make sure the program selector is set
to EDIT.
34
2. Make sure that the SET function at the
bottom of the screen is highlighted.
• If it is not, move the arrow down the screen
with the FlexiZone controller to the bottom
line. Then press the Flexizone controller
sideways to change the highlighted function.
3. Start the tape with the "Play" button: ►.
• Rewind the tape first, and press COUNTER
RESET.
• You can use the ►,
II, and ■
buttons in the same way as in playback mode.
4. At the start of a scene you want to
record, press the FLEXIZONE AE
button.
EDIT TOTAL 0:17:19
STOP
CUT-IN
CUT-OUT
0:37:54
0:01:20* 0:04:05
0:15:03* 0:18:20
►SH DELETE PREVIEW START CLEAR
6. You can program the Auto Editing
Function to remember up to 8 different
scenes in the same way.
5. Press it again at the end of the scene.
• The beginning and end of the scene according
to the counter (the "cut-in" and "cut-out"
points) are displayed on the screen.
• The camera will not let you put in a "cut-in"
point later than its "cut-out" point, nor a "cut¬
out" point earlier than its "cut-in" point.
Notes:
• TOTAL at the top of the menu tells you the total
running time of all the scenes you have selected.
• To ensure smooth running of the tape, do not put
any "cut-in" or "cut-out" points in the first or last
10 seconds of camcorder's tape.
Advertisement
Table of Contents
