Table of Contents
Advertisement
3.2 Power supply
The power supply of M-Bus Master MultiPort 250L is the switch mode type which requires voltage between 100 V and 240 V.
The frequency can be 50 Hz or 60 Hz.
The mains cable is connected to the master through the associated gland. The diameter must be between 4 and 8 mm.
The master is supplied without mains cable and we recommend a fixed installation, i.e. without using a mains plug as this
would reduce reliability of operation.
3.3 USB
M-Bus Master MultiPort 250L's USB-connection can be used for M-Bus communication on an equal basis with the other
serial connections.
The following communication speeds can be used for M-Bus communication:
•
300 Baud 8E1
•
2400 Baud 8E1
•
9600 Baud 8E1
USB version 2.0, which allows up to 5 m cable length, is used. In connection with other USB versions than 2.0 the maximum
cable length recommended is 3 m.
The master's integrated port controller makes sure that communication is only possible on one serial port at a time.
The master is available with a factory-mounted 145 cm cable fitted with a USB connector type A.
To be able to communicate with M-Bus Master MultiPort 250L via USB the corresponding USB driver must be installed on
the computer used for reading.
The program is available on Kamstrup's home page.
USB connector type A
55121391_B1_GB_12.2013
9
Advertisement
Table of Contents
