Yamaha GX-50 Owner's Manual page 33

RECEIVING RDS STATIONS
1
2
3
1 3, 6
MINI COMPONENT SYSTEM
GX–50
1
2
3
LOCATION
MUSIC
TUNER
BAND
USER MEMORY
TAPE 1/2
REC/PAUSE
MODE
DOLBY NR
POWER
PHONES
TIMER REC
AUTO/MAN'L
TIMER
HOUR
1
PLAYBACK
EJECT
<
U.K. and Europe models only
4 5 2
DISC CHANGE
OPEN/CLOSE
VOLUME
CD
DOWN UP
AUX
NORMAL
HIGH
DUBBING
MEMORY
Active Servo
Technology
TIME ADJ
MIN
2
REC/PLAYBACK
EJECT
>
Other functions which make use
of RDS data service
This unit has the following functions which make use of RDS
data service. These are originally in operation [ON].
However, you can cancel these functions [OFF], if so
desired.
>
ON (OFF) CT
This unit corrects the time of the built-in clock
automatically by synchronizing it with the CT data on the
RDS station being received.
* If you receive an RDS station of some other country,
the built-in clock is synchronized with the time setting
of the country.
* If the built-in clock is not yet set for current time or
reset due to a power failure etc., it will be set for the
time of the CT data automatically, whether this setting
is ON or OFF.
ON (OFF) LOCAL
If the RDS station being received employs the local time
(summer time etc.) data service, its time is displayed in
the CT mode.
* If the setting of function
synchronized with the local time data.
ON (OFF) A. M.
Only RDS stations are searched instead of all FM
stations by the automatic preset tuning operation when
the setting is ON.
(See page 19 for the operating procedure.)
If you switch this function OFF, not only RDS stations but
also other FM stations are programmed along with MW
and LW stations by the automatic preset tuning
operation.
To switch these functions on and off
1
Select the FM band by pressing the BAND button,
watching the display.
2
Press the DISPLAY button to display the current time.
3
Press the FREQ PS/PTY/RT/CT selector button.
The title of function
4
Select the title of function whose setting you want to
switch by pressing the PTY SEEK MODE button once or
more.
5
Switch the function ON or OFF by pressing the PTY SEEK
START button, watching the display.
6
Press the FREQ PS/PTY/RT/CT selector button again to
restore the frequency display mode.
* If the station has PS data, after that, it turns into the PS
mode.
Notes
• Once the setting is changed, it will be stored until it is
changed again by the above operation.
• During the operation, if there is no operation for about 20
seconds, this mode is canceled and turns into the
frequency display.
If the station has PS data, after that, it turns into the PS
mode.
E-23
CLOCK
>
CT
is "ON", the built-in clock is
>
RDS
>
"ON CT CLOCK " is displayed.