Page 1
INaac010V01_US_CA AB1-010 FR: INSTRUCTIONS D’ASSEMBLAGE EN: ASSEMBLY INSTRUCTION FR: IMPORTANT : A LIRE ATTENTIVEMENT ET À CONSERVER POUR CONSULTATION ULTÉRIEURE. EN: IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
SAFETY AND MAINTENANCE Please fully understand and follow all safety instructions outlined below. Failure to do so could result in severe injury or death. ・ Do not use open flame heaters in your ice shelter, injury or death may result from fire if tent fabric is exposed to open flame. ・...
Page 3
ASSMBLY INSTRYCTION Step 1: Remove the fish inn from the case pocket, placing ice spikes on the ground. take out the pouch containing the ice spikes and straps. Remove the webbing strap around the fish inn Step 2: Place the fish inn on the ground and check to see if the canvas is twisted or if it covers the ends of the rods.
Page 4
Step 3A: Lifting the roof of shelter up, pull outward on the center hub of one of the walls. Continue around the entire shelter, pulling each wall hub until all of walls are set up. **Tip-Before pulling on the wall hub, place your foot on the floor skirt to hold the shelter in place.
Page 5
Disassembly Instruction * *Tip – Make sure that all doors are closed. Close all Windows and vents, and remove all ice and snow from the Fish Inn before take down. Step 1: Step 2: Unscrew the ice spikes from the four inside corners Push in firmly on one of the center hubs of the and remove all tie down from the outside wall.
Need help?
Do you have a question about the AB1-010 and is the answer not in the manual?
Questions and answers