Memory Mode - Yaesu VX-127 Operating Manual

You may wish to append an alpha-numeric "Tag" (label) to a memory or memories, to aid
in recollection of the channel's use (such as a club name, etc.). This is easily accomplished
using the Set Mode.
1. Recall the memory channel on which you wish to append a label.
2. Press the [ SET ( ) EMG ] key momentarily to enter the Set mode.
3. Rotate the DIAL knob to select Set Mode Item 29:
4. Press the [ F ] key momentarily to display the previously
stored label (if any).
5. Press the [ F ] key again to clear any previous label.
6. Rotate the DIAL knob to select the first digit of the desired
label.
7. Press the [ F ] key to move to the next character.
8. If you make a mistake, press the [ ( MHz )] key to back-
space the cursor, then re-enter the correct letter, number,
or symbol.
9. Repeat steps 5 through 7 to program the remaining letters,
numbers, or symbols of the desired label. A total of six charac-
ters may be used in the creation of a label.
10. When you have programmed a label which is under 6 characters,
press and hold in the [ F ] key for one second to confirm the label (if the label is exactly 6
characters in length, you do not need to press and hold in [ F ] key).
11. When you have completed the creation of the label, press the
PTT switch to save the label and return to the memory recall
mode with labeled (alpha-numeric "Tag") display.
To disable the alpha-numeric Tag (enabling the frequency display):
1. Set the VX-127 to the "MR" (Memory Recall) mode, and recall the memory channel
on which you wish to disable the alpha-numeric Tag.
2. Press the [ SET ( ) EMG ] key momentarily to enter the Set mode.
3. Rotate the DIAL knob to select the Set Mode Item 28:
4. Press the [ F ] key momentarily to enable adjustment of this Item's
setting.
5. Rotate the DIAL knob to set this Set Mode Item to "
(enabling the frequency display).
6. Press the PTT switch to save the new setting and activate the
alpha-numeric Tag.
To display the alpha-numeric Tag again, just repeat the above procedure, rotating the DIAL
ALPHA
knob to select "
Set Mode Item 28:NAME is not applied to all memory channels at once (just
the channel on which you currently are operating).
VX-127 O
L
" in step 5 above.
M
M
M
NM WRT
.
NAME
FREQ
M
EMORY ODE
.
"
31