Yaesu VX-127 Operating Manual page 50

E
MERGENCY
E
The Emergency Automatic ID (EAI) Feature requires that you (1) store the CTCSS Tone
Pair into the Receiving Pager Memory (see page 26 for procedure), and (2) store the desired
coordination frequency into Memory Channel "200" (see page 29 for procedure).
To enable this feature:
1. Press the [ SET ( ) EMG ] key momentarily to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 53: EAI.
3. Press the [ F ] key momentarily to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select the desired EAI mode (
CON
EAI or tinuous EAI) and its transmit time (1-10, 15, 20,
30, 40, and 50 minutes) or OFF.
5. Press the PTT switch to save the new setting and exit to normal operation.
6. To disable the Emergency Automatic ID feature, just repeat the above procedure, ro-
tating the DIAL knob to select "OFF" in step 4 above.
When the Emergency Automatic ID feature is activated, the "
icon will blink in the LCD.
The VX-127 will ignore the EAI feature when the (1) the squelch is open, (2)
there is an incoming the signal on the operating frequency, or (3) the operat-
ing frequency is the same as the frequency which is stored in the Memory
Channel "200."
48
F
EATURE
A ID EAI F
INT
terval
"
VX-127 O M