Mounting The Door; Installing Interior Fittings; Installing Exterior Benches; Installing Accessories - Sentiotec KASKI 240 VIEW Canopy Assemble Instructions

Installation instructions p. 8/8
Before tensioning the metal bands, remove the screws from the staves. Tighten
the metal bands so that there is no visible gap between the staves. This must
be checked regularly and retightened if necessary.

2.5. Mounting the door

Place the door frame[13,17] in the opening from the inside. Note that the door
opens outwards – the door can be attached on the left or on the right.
Fix the door in place from the outside using the cover strips[15].
The door handles are screwed from the inside.

2.6. Installing interior fittings

Fit the bench support slats[9a,c] at a height of approx. 52 cm to the lower
stave.
Position the benches[18a] and screw them to the stave. Attach the supports[37]
to the benches.
Mount the backrests[19] approx. 20 cm above the bench.

2.7. Installing exterior benches

Fit the bench support slats[9a,b] at a height of approx. 52 cm to the lower stave.
Place the benches[18b] on the bench support slats and mount the feet[37].

2.8. Installing accessories

Fit the ventilation grille[38] and the stopper[34] in the lower stave. Position the
floor grid[11] so that it is level.
Assemble the protection grille[35,36].
Mount the ventilation panel[29] on the inside and the insect screen[28] on the
outside.
For the lighting, first fit the metal clips on the wooden strip. Clamp the LED
strip[22] and drill a hole for the cable gland at the desired location (the power
supply unit may be placed outside the sauna).
Use the cable cover slats[21a,b] as required for the cable installation.

2.9. Covering the roof

Install the triangular strips[10] (drip edge) at a height of approx. 116 cm.
Start attaching the bitumen shingles[30] at the triangular strip, with the top of the
first shingle sheet facing down. Now lay the other shingle sheets overlapping
and evenly offset. You can make the top ridge row from sections. These are laid
overlapping in a scale-like manner. Pay attention to the prevailing wind direction.
The mounting strips on the inner walls can now be removed.