m
DANGER!
Risk of injury! Improper use may result
u
in personal injury . Use the product only
as described in the user manual . Never
attempt to alter the product in any way .
DANGER!
m
Risk of injury! Never use a damaged
u
product . Disconnect the product from the
power supply and contact your retailer if
the product is damaged .
Make sure that the nominal voltage on the
rating plate complies with the supply voltage .
If possible, only operate the product on an
electrical circuit protected by a fault current
switch and a fuse of at least 10 A .
The use of extension cords is not
recommended . If the use of an extension cord
is necessary, it must be designed for a current
flow of at least 10 A .
Shield the power cord and power plug from
dust, direct sunlight, dripping and splashing
water .
Protect the power cord from damage . Do
not allow the power cord to hang over sharp
corners; do not crush or bend it . Keep the
power cord away from any hot surfaces and
open flames .
Do not operate the product if the power
cord or power plug are damaged, nor if the
product does not work or is damaged in any
way .
If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard .
Do not disconnect the power plug from the
socket outlet by pulling on the power cord .
Special safety information for rope
hoists
Persons who intend to use the product
must first receive appropriate training or
instructions .
It is prohibited to move persons with the
product .
It is prohibited to lift loads in excess of the
nominal load .
Do not attempt to lift stuck or jammed loads .
The steel cable must be taut when lifting the
load .
Do not pull the loads in horizontal direction .
Avoid switching the product on and off
rapidly (inching operation) .
Always be attentive when operating the
product .
Do not leave hanging loads unattended
without taking appropriate safety measures .
Do not stand or work underneath raised
loads .
The product has not been outfitted with a
rated power limit . Do not attempt to lift the
load further when the overheat protection
limits operation . In this case, the load has
exceeded the product's nominal power .
GB
9