Hang the pulley
[
11 ]
steel cable
(Fig . G) .
14 ]
[
Attach the screws and the extra hook
the pulley
. Fasten the 3 screws (Fig . H) .
[
11 ]
The block and tackle is now operational
(Fig . I) .
Cleaning and care
m
WARNING!
Disconnect the device from the power supply
before inspections, maintenance or cleaning!
Cleaning
Ensure that no water enters the product
interior .
Regular, proper cleaning helps ensure safe
operation and lengthens the service life of
your product .
Clean the product with a dry cloth . Use a soft
brush for hard-to-reach areas .
NOTE
Do not use any chemical, alkaline, abrasive
u
or otherwise aggressive cleaning or
disinfecting agents to clean the product as
they may damage its surfaces .
12 GB
in the loop formed by the
to
10 ]
[
Maintenance
Test interval
Procedure
Before each use
Check whether the emergency
off switch
switch
functioning .
Every 30 cycles* Check the entire steel cable
14 ]
[
Replace the steel cable
if damaged (available at
specialist retailers) .
Every 100 cycles* Check to ensure the
maximum/minimum length
levers
functional without load .
Every 200 cycles* Lubricate the steel cable
and the pulley
Every 800 cycles* Make sure all screws are
securely fastened .
Check the entire product for
signs of wear .
* One cycle corresponds to one upward and
downward movement of a load .
Repairs
There are no parts in the product interior that
can be repaired by the user . Contact a qualified
professional to have the product checked and
repaired .
and control
[
7 ]
are properly
8 ]
[
for damages (Fig . K) .
are fully
[
15 ]
[
16 ]
14 ]
[
.
11 ]
[