Winding/Unwinding The Cable; Lifting Loads; Maximum/Minimum Length Levers; Emergency Off Switch - Parkside 373100 2104 Operation And Safety Notes

˜ Winding/unwinding the cable
(Fig . J)
Winding the cable: Press the control
switch upwards according to the arrow
[ 8 ]
indication .
Unwinding the cable: Press the control switch
downwards according to the arrow
[ 8 ]
indication .
˜ Lifting loads
Lower the steel cable
comfortably .
Fasten the load to the hook
additional bungee cords where necessary .
The load's centre of gravity must be beneath
the product .
Wind up the steel cable
Then fully lift the load .
˜ Maximum/minimum length
levers
NOTE
The maximum/minimum length levers
u
are not intended to regularly stop the
16 ] [
product . Always attempt to stop the product
before it triggers one of these levers .
Minimum cable length lever
When the steel cable
14 ] [
minimum cable length lever
The steel cable cannot be wound up any further . It
can only be unwound .
Maximum cable length lever
When the steel cable
14 ] [
maximum cable length lever
The steel cable cannot be unwound any further . It
can only be wound up .
so you can handle it
14 ] [
. Use
10 ] [ [ 12 ]
until it is only taut .
14 ] [
15 ] [
is fully wound up, the
will be triggered .
[ 15 ]
is fully unwound, the
will be triggered .
[ 16 ]
˜ Emergency off switch
(Fig . J)
In case of an emergency, press the

emergency off switch

lowering operation .
The product is then locked . To unlock the
product, turn the emergency off switch
slightly clockwise (in the direction of the
arrow) until it pops out .
˜ Set-up as block and tackle
Accessories
The following tools are needed for the safe and
proper use of the block and tackle function:
2 spanners (8 mm)
2 spanners (13 mm)
WARNING
m
Do not use any accessories not
u
recommended by Parkside .
Setting up the product as a block and tackle
distributes the load to 2 pulleys . This allows twice
the weight to be lifted . However, the maximum
lifting height and speed are reduced by half .
Fasten the hook
12 ] [
opening . The steel cable
18 ] [
loop (Fig . C) .
Dismantle the pulley
Remove the 3 screws (Fig . F) .
to stop lifting or
7 ] [
7 ] [
to the intended mounting
now forms a
14 ] [
of the extra hook:
11 ] [
GB 11