Power Button; Removing The Power Button - Dell NOT22208 Owner's Manual

Next steps
1. Install the assembly-inner
2. Install the battery.
3. Install the heat sink (discrete GPU)
4. Install the M.2 2230 solid-state drive in Slot
5. Install the M.2 2230 or
6. Install the memory modules.
7. Install the WLAN card.
8. Install the 4G WWAN card
9. Install the base cover.
10. Install the SIM card.
11. Follow the procedure in

Power button

Removing the power button

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the 4G WWAN card
6. Remove the WLAN card.
7. Remove the memory modules.
8. Remove the M.2 2230
9. Remove the M.2 2230 solid-state drive from Slot
10. Remove the heat sink (discrete GPU)
11. Remove the assembly-inner
12. Remove the system board.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
90 Removing and installing Field Replaceable Units (FRUs)
frame.
or heat sink (integrated
2, if applicable.
M.2 2280 solid-state drive in Slot 1, as applicable.
or 5G WWAN card, as applicable.
After working inside your
Before working inside your
or 5G WWAN card, as applicable.
or M.2 2280 solid-state drive from Slot 1, as applicable.
or heat sink (integrated
frame.
GPU), as applicable.
computer.
computer.
2, if applicable.
GPU), as applicable.